Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When replacing LBC simultaneously, perform the work procedure of Li-ion battery controller replacement. Refer to WORK PROCEDURE .

REMOVAL OF MODULE

Remove module. Refer to DISASSEMBLY AND ASSEMBLY .

GO TO STEP 2 .

ADJUSTMENT OF MODULE VOLTAGE

Adjust the voltage of module requiring replacement. Refer to WORK PROCEDURE .

GO TO STEP 3 .

INSTALLATION OF MODULE

Install new module. Refer to DISASSEMBLY AND ASSEMBLY .

When one module is replaced

WORK END

When all modules are replaced

GO TO STEP 4 .

CLEAR LBC INTERNAL INFORMATION

With CONSULT
1. Select "WORK SUPPORT" mode of "HV BAT".
2. Select "CLEAR BATTERY INFORMATION".
3. Touch "CLEAR".
WORK END