LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> Removal And Installation >> Rear Oil Seal >> VQ37VHR >> VQ37VHR: Removal and Installation >> Installation

VQ37VHR: Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply transfer fluid to rear oil seal, install it with the drifts (A and B) within the dimension (L) shown as follows.
    Fig 1: Installing Rear Oil Seal Using Drifts
    G09002561Courtesy of NISSAN NORTH AMERICA, INC.

    L: 6.7 - 7.3 mm (0.264 - 0.287 in) 

    CAUTION:
    • Never reuse rear oil seal.
    • Apply petroleum jelly to oil seal lip.
    • When installing, never incline rear oil seal.
  2. Align the matching mark (A) of main shaft with the mark (B) of companion flange, then install the companion flange.
    Fig 2: Aligning Matching Marks On Main Shaft And Companion Flange
    G05727164Courtesy of NISSAN NORTH AMERICA, INC.
  3. Using a flange wrench (A) (commercial service tool), install the self-lock nut of companion flange and tighten to the specified torque. Refer to "VQ37VHR: EXPLODED VIEW ".
    CAUTION: Never reuse self-lock nut.
    Fig 3: Installing Self-Lock Nut Of Companion Flange Using Wrench
    G05979336Courtesy of NISSAN NORTH AMERICA, INC.
  4. Install the rear propeller shaft. Refer to "EXPLODED VIEW ".
  5. Check fluid level. Refer to "VQ37VHR: INSPECTION ".
scientia non olet · About LEMON Manuals