LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> Removal And Installation >> Front Oil Seal >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply transfer fluid to outside of front oil seal, install it with a drift (A) [SST: ST27862000 (-)] until the end face of front case.
    CAUTION:
    • Never reuse front oil seal.
    • Apply petroleum jelly to oil seal lip.
    • When installing, never incline front oil seal.
    Fig 1: Installing Front Oil Seal Using Drift
    G05727161Courtesy of NISSAN NORTH AMERICA, INC.
  2. Install front propeller shaft. Refer to "VQ37VHR: EXPLODED VIEW " (VQ37VHR), "VK50VE: EXPLODED VIEW " (VK50VE).
  3. Fill with new transfer fluid, check fluid level and for fluid leakage. Refer to "VQ37VHR: INSPECTION " (VQ37VHR), "VK50VE: INSPECTION " (VK50VE).
scientia non olet · About LEMON Manuals