Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) harness connector.
3. Check the voltage between ABS actuator and electric unit (control unit) harness connector and ground.

   ABS actuator and electric unit (control unit)		-	Voltage
   Connector	Terminal
   E41	28	Ground	Approx. 0 V

4. Turn the ignition switch ON.
   CAUTION: Never start the engine.
5. Check the voltage between ABS actuator and electric unit (control unit) harness connector and ground.

   ABS actuator and electric unit (control unit)		-	Voltage
   Connector	Terminal
   E41	28	Ground	Battery voltage

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: GO TO 2.

1. Turn the ignition switch OFF.
2. Check the 10A fuse (#45).
3. Disconnect IPDM E/R harness connector.
4. Check the continuity between ABS actuator and electric unit (control unit) harness connector and IPDM E/R harness connector.

   ABS actuator and electric unit (control unit)		IPDM E/R		Continuity
   Connector	Terminal	Connector	Terminal
   E41	28	E5	25	Existed

   Is the inspection result normal? 

   YES: Perform the trouble diagnosis for ignition power supply circuit. Refer to "WIRING DIAGRAM - IGNITION POWER SUPPLY - ".

   NO: Repair or replace error-detected parts.

1. Turn the ignition switch OFF.
2. Check the 50A fusible link (#N) and 30A fusible link (#M).
3. Check the voltage between ABS actuator and electric unit (control unit) harness connector and ground.

   ABS actuator and electric unit (control unit)		-	Voltage
   Connector	Terminal
   E41	2	Ground	Battery voltage
   	3

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Perform the trouble diagnosis for battery power supply circuit. Refer to "WIRING DIAGRAM - BATTERY POWER SUPPLY - ".

Check the continuity between ABS actuator and electric unit (control unit) harness connector and ground.

Is the inspection result normal? 

YES: INSPECTION END

NO: Repair or replace error-detected parts.