LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> G37 IPL, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Automatic Transmission -- G37 Coupe) >> Removal And Installation >> Fluid Cooler System >> 2WD >> 2WD : Removal and Installation >> Removal

2WD : Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove air cleaner case (LH). Refer to "EXPLODED VIEW ".
  2. Remove engine lower cover with a power tool. Refer to "EXPLODED VIEW ".
  3. Remove A/T fluid cooler hose A and A/T fluid cooler hose B.
  4. Remove the exhaust mounting bracket with power tool. Refer to "EXPLODED VIEW ".
  5. Remove the A/T fluid cooler tube mounting bolts and bracket.
  6. Remove the band fixing two A/T fluid cooler tubes.
  7. Remove the stabilizer clamp from the front suspension member. Refer to "EXPLODED VIEW ".
  8. Remove the lower mounting nuts for the engine mounting insulators (RH and LH). Refer to "2WD : EXPLODED VIEW ".
  9. Set a jack under the engine to lift it to the position where the A/T fluid cooler tube can be removed.
    CAUTION:
    • Never set a jack on the engine oil pan.
    • Never pull the harnesses, hoses, etc. excessively.
  10. Remove the A/T fluid cooler tubes one at a time from the vehicle.
    CAUTION: Be careful not to bend A/T fluid cooler tubes.
  11. Plug up opening such as the A/T fluid cooler tube holes.
scientia non olet · About LEMON Manuals