Removal and Installation: Installation
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- Start the engine.
- Use CONSULT-II to perform "STANDARD HEIGHT LEVEL" work support function.
- Using data monitor of CONSULT-II, verify "HEIGHT CALC" is at 0 mm.
- Check the vehicle height. Refer to "WHEELARCH HEIGHT (UNLADEN*1) ". If vehicle height is not within +/- 10 mm (0 +/- 0.39 in) of the specification, perform the initialization procedure. Refer to "INITIALIZATION PROCEDURE ".