Initialization Procedure
WARNING: This page is about a different car, the 2005 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.
- If control unit has been replaced, proceed to step 2. If control unit has not been replaced, use CONSULT-II "CLEAR HEIGHT INI" work support function to clear initialization flag and value. The CK SUSP warning lamp should illuminate. Using CONSULT-II "EXHAUST SOLENOID" active test, release the air pressure from the rear load leveling air suspension system.
- Roll vehicle forward and backward.
- Use CONSULT-II "ADJUST HEIGHT INI" work support function to set initialization condition.
- Confirm that CK SUSP warning lamp is OFF.