LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Assembly Replacement (LHD) >> Removal Procedure

Removal Procedure

    Fig 1: Brake Pedal Assembly
    GM1619031Courtesy of GENERAL MOTORS CORP.
  1. Remove the knee bolster. Refer to Driver Knee Bolster Replacement (Left Hand Drive) or Driver Knee Bolster Replacement (Right Hand Drive) .
  2. Remove the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement (Left Hand Drive) or Driver Knee Bolster Bracket Replacement (Right Hand Drive) .
  3. Disconnect the electrical connectors (1) for the brake switches. Refer to Stop Lamp Switch Adjustment .
  4. Remove the bolts and lower the steering column.

    Do not disconnect the steering column from the intermediate shaft.

  5. Remove the clevis pin retainer (2).
  6. Remove the clevis pin (3).
  7. Remove the 4 master cylinder nuts (4).
  8. Remove the brake pedal bracket bolts (5)
  9. Remove the brake pedal assembly (6).
scientia non olet · About LEMON Manuals