LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Fixed & MOVEABLE Window Systems) >> Repair Instructions >> Rear Side Door Window Replacement

Rear Side Door Window Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Door Window & Bolts
GM1673175Courtesy of GENERAL MOTORS CORP.
Rear Side Door Window Replacement

Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Position the rear door window approximately half way down in the door.
  3. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Suburban/Yukon XL/Escalade ESV) or Rear Side Door Trim Panel Replacement (Tahoe/Yukon/Escalade) .
  4. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  5. Remove the rear door window channel. Refer to Rear Side Door Window Channel Replacement .
1 Rear Door Window Bolts (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  7 N.m (61 lb in)


Tip:  Loosen the 2 bolts that attach the window to the window regulator.
2 Rear Door Window