Rear Side Door Trim Panel Replacement (Tahoe/Yukon/Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Trim Panel Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove rear door window control switch. Refer to Rear Side Door Window Switch Replacement .
1	Detent Tab
2	Rear Side Door Locking Rod Knob Assembly Tip: Lower window. Ensure locking rod is in the unlocked position. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward. When re-installing, push knob down, until detent tab touches locking rod opening cover. Push detent tab in to lock knob to locking rod.
3	Rear Side Door Trim Panel Cover
4	Rear Side Door Trim Panel Cover Retainer (Qty: 4)
5	Rear Side Door Inside Handle Bezel Cover
6	Rear Side Door Trim Panel Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
7	Rear Side Door Trim Panel Assembly
8	Rear Side Door Cable Retainer Tip: Pull upward to disengage.
9	Rear Side Door Trim Panel Retainer (Qty: 10)