LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Multifunction Switch Replacement

Turn Signal Multifunction Switch Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Multifunction Turn Signal Switch & Screws
GM1701070Courtesy of GENERAL MOTORS CORP.
Turn Signal Multifunction Switch Replacement

Callout Component Name
CAUTION: Refer to SIR Caution .

Preliminary Procedure

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the steering wheel. Refer to Steering Wheel Replacement .
1 Multifunction Turn Signal Switch Screws (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  3 N.m (27 lb in)

2 Multifunction Turn Signal Switch
Tip:  Disconnect the electrical connectors.