LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement (Chevrolet/GMC) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Washer Solvent Container & Screws
    GM1669972Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left front wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
    4. Fig 2: Locating Washer Pump Hoses
    GM1733021Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the washer pump hoses (1,2) from the left side fender flange. Refer to Hose Replacement - Windshield Washer .
  5. Drain the windshield washer solvent into a suitable container.
  6. Disconnect the electrical connectors.
  7. Lower the vehicle in order to access the hood latch.
  8. Open the hood.
  9. Remove the windshield washer solvent cap.
  10. Remove the auxiliary battery tray, if equipped. Refer to Battery Tray Replacement .
    11. Fig 3: View Of Wheelhouse & Windshield Washer Solvent Container Assembly
    GM1733024Courtesy of GENERAL MOTORS CORP.
  11. Remove the upper windshield washer container bolt from under the auxiliary battery tray, if equipped.
    12. IMPORTANT: Remove the washer container from the underside of the vehicle through the wheelhouse opening.
  12. Remove the windshield washer solvent container assembly (2).
scientia non olet · About LEMON Manuals