Inflatable Restraint Passenger Presence System Replacement - Front

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Passenger Presence System Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Rezeroing .
1	Front Seat Recliner Lever (If Equipped) Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
2	Front Seat Adjuster Outer Finish Cover Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat (Manual) or Seat Cushion Outer Trim Panel Replacement - Front Seat (Power) .
3	Front Seat Adjuster Inner Finish Cover Refer to Seat Cushion Inner Trim Panel Replacement - Front .
4	Front Seat Cushion Cover and Pad Tip: Disengage the j-channel retainers from the seat cushion frame. Remove the seat cushion cover and pad from the seat cushion frame as an assembly.
5	Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)
6	Inflatable Restraint Front Passenger Presence Sensor Tip: Lay the seat on it's side. Unhook connector from retainer on seat frame and push up through seat pan. Disconnect and remove sensor.
7	Front Seat Adjuster Assembly Refer to Front Seat Adjuster Replacement (Manual) or Front Seat Adjuster Replacement (Power) .
8	Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2) Tip: Drill out the rivets to remove and install using new rivets.
9	Inflatable Restraint Front Passenger Presence Module