LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement - Front Seat (Power)

Seat Cushion Outer Trim Panel Replacement - Front Seat (Power)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Seat Adjuster Outer Finish Cover & Screw
GM1678374Courtesy of GENERAL MOTORS CORP.
Seat Cushion Outer Trim Panel Replacement - Front Seat (Power)

Callout Component Name
1 Front Seat Adjuster Outer Finish Cover Screw
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)

2 Front Seat Adjuster Outer Finish Cover
Tip: 
  1. Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
  2. Pull outward to release the retainers from the seat assembly.
  3. Disconnect the electrical connectors.
  4. If replacing the finish cover, remove the switches and install on new finish cover.