Rear Seat Number 2 Load Floor Latch Cable Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat No. 2 Back Cushion Latch, Nuts & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the rear seat. Refer to Rear Number 2 Seat Replacement (Suburban/Yukon XL) or Rear Number 2 Seat Replacement (Tahoe/Yukon/Escalade) . Remove the rear seat cushion trim covers. Refer to Seat Cushion Panel Replacement - Rear No. 2 (AS3) or Seat Cushion Panel Replacement - Rear No. 2 (AW2) .
1	Rear Seat Latch Release Handle Refer to Rear Seat Latch Release Handle Replacement (Rear No. 2) .
2	Rear Seat No. 2 Back Cushion Latch Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
3	Rear Seat No. 2 Back Cushion Latch Bolt (Qty: 2) Tighten: 9 N.m (80 lb in)
4	Rear Seat No. 2 Back Cushion Latch Tip: Release the latch cables from the seat, note the locations for installation.