Rear Seat Back Cushion Cover and Pad Replacement (Tahoe/Yukon/Escalade with Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Back Cushion Cover, Pad & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear seat. Refer to Rear Seat Replacement (Avalanche/Escalade EXT) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench) .
1	Rear Seat Head Restraint Tip: Depress the button on the inboard head restraint guide to raise the head restraint to the full up position. Insert a small diameter tool into the hole on the inboard side of the outboard head restraint guide and pull upward to remove.
2	Rear Seat Head Restraint Guides Tip: Squeeze the bottom of the head restraint guide together and push up to remove.
3	Rear Seat Back Cushion Cover Tip: Disconnect the seat back cushion cover j-channel from the seat cushion frame. Disconnect the electrical connector if equipped with heated seat. Pull the seat back cushion cover away from the seat cushion pad to disengage the retaining channel.
4	Rear Seat Back Cushion Pad