LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench)

Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Assembly & Nuts
GM1679197Courtesy of GENERAL MOTORS CORP.
Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench)

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
1 Rear Seat Assembly Forward Nut (Qty: 4)
Tip:  Fold the seat forward and remove the floor cover to access the nuts.

Tighten:  45 N.m (33 lb ft)
2 Rear Seat Assembly Rearward Nut (Qty: 4)

Tighten:  45 N.m (33 lb ft)
3 Rear Seat Assembly
Tip: 
  1. Disconnect the electrical connector, if equipped.
  2. Remove the seat with the aid of an assistant; the seat is very heavy.
scientia non olet · About LEMON Manuals