LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 447 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Auxiliary Air Conditioning Evaporator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging (Non-HP2) , Refrigerant Recovery and Recharging (HP2) .
  2. Fig 1: View Of Auxiliary A/C Evaporator Tubes At Condenser Tube & Accumulator
    GM612568Courtesy of GENERAL MOTORS COMPANY
  3. Remove the auxiliary A/C evaporator tubes (3) from the condenser tube (2) and the accumulator (5).
  4. Loosen the right front wheelhouse to gain access to the clamp behind the wheelhouse.
  5. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  6. Remove the right assist step. Refer to Assist Step Replacement (GMC Denali XL) , Assist Step Replacement (Chevrolet HP2) , Assist Step Replacement (Power BRS) , Assist Step Replacement (Z71) .
  7. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  8. Remove the rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement (RPO X88 Chevrolet, RPO O88 GMC) , Rear Wheelhouse Panel Liner Replacement (RPO HP2) .
  9. Fig 2: View Of Auxiliary A/C Evaporator Tubes & Nut & Auxiliary HVAC Module
    GM691871Courtesy of GENERAL MOTORS COMPANY
  10. Remove the retaining nut (2) and the auxiliary A/C evaporator tubes (3) from the auxiliary HVAC module.
  11. Fig 3: View Of Auxiliary Heater Pipes, Clamps & Heater/A/C Tubes Retaining Nut & Stud
    GM691870Courtesy of GENERAL MOTORS COMPANY
  12. Remove the heater/A/C tubes retaining nut (4) from the stud (1) at the frame (6).
  13. Remove the auxiliary A/C evaporator tubes (3) from the clamps (5).
  14. Remove the auxiliary A/C evaporator tubes from the vehicle.