Rear Seat Riser Replacement (Tahoe/Yukon/Escalade with Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Riser & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the rear seat. Refer to Rear Seat Replacement (Avalanche/Escalade EXT) , Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench) , Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) .
1	Rear Seat Riser Finish Cover Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
2	Rear Seat Riser Finish Cover (Qty: 2)
3	Rear Seat Riser Finish Cover (Qty: 2)
4	Rear Seat Riser Bolt (Qty: 4) Tighten 9 N.m (80 lb in)
5	Rear Seat Assembly Procedure Disconnect the seat riser struts from the seat riser and lift the seats off the riser assembly.
6	Rear Seat Riser