LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Replacement (Avalanche/Escalade EXT)

Rear Seat Replacement (Avalanche/Escalade EXT)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Assembly, Nuts & Rear Seat Belt Buckle Anchor Nut
GM1679196Courtesy of GENERAL MOTORS COMPANY
Rear Seat Replacement (Avalanche/Escalade EXT)

Callout Component Name

Preliminary Procedures

  1. Remove the jack access cover and jack from the vehicle.
  2. Remove the rear seat track finish cover.
1 Rear Seat Assembly Nut (Qty: 7)
CAUTION:

Refer to Fastener Caution .


TIP:  Remove the adjuster cover to access the nuts.
Tighten 
45 N.m (33 lb ft)
2 Rear Seat Belt Buckle Anchor Nut
TIP:  The nut is located behind the seat.
Tighten 
45 N.m (33 lb ft)
3 Rear Seat Assembly
Procedure 
Disconnect the electrical connector, if equipped.
scientia non olet · About LEMON Manuals