LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 343 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement (1500) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the front axle hub cap from the wheel bearing, if equipped.
    4. Fig 1: Securing Brake Rotor
    GM1932Courtesy of GENERAL MOTORS CORP.
  4. Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.
    5. Fig 2: Hub Nut And Washer
    GM1736696Courtesy of GENERAL MOTORS CORP.
    NOTE:

    DO NOT reuse the wheel drive shaft nut, use a NEW nut only.

  5. Remove the nut (1) and washer (2) from the hub.
    6. Fig 3: Pressing Wheel Drive Shaft From Hub
    GM870456Courtesy of GENERAL MOTORS CORP.
  6. Using the J-45859  Axle Remover, remove the wheel drive shaft from the hub.
    7. Fig 4: Drive Flange And Retaining Bolts
    GM1736718Courtesy of GENERAL MOTORS CORP.
  7. Remove the retaining bolts from the drive flange.
  8. Remove the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (2500) , Stabilizer Shaft Replacement (1500) .
  9. Remove the shock module. Refer to Shock Absorber and Spring Removal and Installation .
    10. Fig 5: Wheel Drive Shaft
    GM1736759Courtesy of GENERAL MOTORS CORP.
  10. Remove the wheel drive shaft through the lower control arm opening.
  11. Remove all dirt and debris from the splines on the wheel hub/bearing.
scientia non olet · About LEMON Manuals