LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 343 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement (1500) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Drive Shaft
    GM1736759Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft in the steering knuckle.
    2. Fig 2: Hub Nut And Washer
    GM1736696Courtesy of GENERAL MOTORS CORP.
    NOTE:

    Install the NEW nut and washer, but DO NOT tighten at this time.

  2. Install the NEW nut (1) and washer (2).
    3. Fig 3: Drive Flange And Retaining Bolts
    GM1736718Courtesy of GENERAL MOTORS CORP.
  3. Install the retaining bolts and finger tighten.
    4. Fig 4: Securing Brake Rotor
    GM1932Courtesy of GENERAL MOTORS CORP.
  4. Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Tighten the wheel driver shaft retaining bolts and tighten to 79 N.m (58 lb ft).
  6. Tighten the wheel drive shaft retaining nut and tighten to 240 N.m (177 lb ft).
  7. Install the shock module. Refer to Shock Absorber and Spring Removal and Installation .
  8. Install the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (2500) , Stabilizer Shaft Replacement (1500) .
  9. Install the front axle hub cap to the wheel bearing, if equipped.
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals