LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 312 (Steering Wheel And Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shift Lever And Screw
    GM1700835Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lever (1).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the shift lever bolt (2) and tighten to 20 N.m (15 lb ft).
  3. Connect all electrical connectors.
  4. Position the shift lever seal.
  5. Install the steering column shroud. Refer to Steering Column Shroud Replacement (With Electronic Tilt Steering) , Steering Column Shroud Replacement (Without Electronic Tilt Steering) .
scientia non olet · About LEMON Manuals