LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Replacement

Hood Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hood
GM1670888Courtesy of GENERAL MOTORS CORP.
Hood Replacement

Callout Component Name
WARNING:

When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Preliminary Procedure

  1. Disconnect the hood strut rod. Refer to Hood Strut Replacement .
  2. Remove the air inlet panel end panels. Refer to Air Inlet Grille Panel Replacement .
1 Hood Link Upper Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
25 N.m (18 lb ft)
2 Hood Hinge Pivot Bolt (Qty: 2)
Tighten 
25 N.m (18 lb ft)
3 Hood
  • Disconnect any electrical connectors before removing.
  • Transfer any parts as needed.
scientia non olet · About LEMON Manuals