LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Strut Replacement

Hood Strut Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hood Strut
GM1674992Courtesy of GENERAL MOTORS CORP.
Hood Strut Replacement

Callout Component Name
WARNING:

When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1 Hood Strut Retainer (Qty: 2)

Procedure

  1. Release the locking tabs on the strut.
  2. Ensure the clip is fully seared when rod is reinstalled. If the clip cannot be fully seated a new rod should be installed.
2 Hood Strut