LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 295 (Wiper System And Washer System) >> Repair Instructions >> Air Inlet Grille Panel Replacement

Air Inlet Grille Panel Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Inlet Grille Panel
GM1673096Courtesy of GENERAL MOTORS CORP.
Air Inlet Grille Panel Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the fixed antenna, if equipped. Refer to Radio Antenna Replacement .
  2. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (Chevrolet Hybrid Two-mode) , Windshield Wiper Arm Replacement (Conventional) .
  3. Remove the rear hood seal. Refer to Hood Rear Seal Replacement .
1 Air Inlet Panel End Panel
2 Air Inlet Panel Retainer (Qty: 2)
3 Air Inlet Panel Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
4 Air Inlet Panel Clip
5 Air Inlet Panel
scientia non olet · About LEMON Manuals