LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Cooler Replacement (without Hydroboost) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fascia grille. Refer to Fascia Grille Replacement (Z71) or Fascia Grille Replacement (Suburban, Tahoe) or Fascia Grille Replacement (Escalade) or Fascia Grille Replacement (Yukon) or Fascia Grille Replacement (GMC Yukon Two-mode Hybrid) .
  2. Remove the radiator grille reinforcement support, if equipped. Refer to Radiator Grille Reinforcement Support Replacement .
  3. Remove as much power steering fluid as possible from the power steering fluid reservoir.
  4. Place drain pans under the vehicle as needed.
    5. Fig 1: View Of Power Steering Pump & Components
    GM1861214Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Power Steering Hose Disconnected Notice .
  5. Disconnect the power steering gear outlet hose (2) from the power steering fluid cooler (4).
  6. Disconnect the power steering fluid cooler hose (3) from the power steering pump (1).
    7. Fig 2: View Of Power Steering Cooler & Bolts (With Hydroboost)
    GM686121Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering fluid cooler bolts (2) from the power steering fluid cooler.
  8. Remove the power steering fluid cooler from the vehicle.
scientia non olet · About LEMON Manuals