Rear Seat Recliner Actuator Replacement (with Bucket Seat)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Seat Recliner Actuator (with Bucket Seat)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Fold the seat forward. Remove the rear seat cushion trim panel. Refer to Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Cushion Trim Panel Replacement (Avalanche/Escalade EXT) or Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Bucket) .
1	Rear Seat Recliner Actuator Screw (Qty: 2) Tighten: 3 N.m (25 lb in)
2	Rear Seat Recliner Actuator Assembly Tip: Disconnect the electrical connector. Disconnect the actuator cable assembly.

Callout

Component Name

NOTE: Refer to Fastener Notice .

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Fold the seat forward.
Remove the rear seat cushion trim panel. Refer to Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Cushion Trim Panel Replacement (Avalanche/Escalade EXT) or Rear Seat Cushion Trim Panel Replacement (Tahoe/Yukon/Escalade with Bucket) .

Rear Seat Recliner Actuator Screw (Qty: 2)

Tighten: 3 N.m (25 lb in)

Rear Seat Recliner Actuator Assembly
Tip:

Disconnect the electrical connector.
Disconnect the actuator cable assembly.