Rear Seat Riser Replacement (Tahoe/Yukon/Escalade with Bucket)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove the rear seat. Refer to Rear Seat Replacement (Tahoe with HP2) or Rear Seat Replacement (Avalanche/Escalade EXT) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Split Bench) or Rear Seat Replacement (Tahoe/Yukon/Escalade with Bucket Seat) . |
|
| 1 | Rear Seat Riser Finish Cover Screw
NOTE:
Refer to Fastener Notice
.
Tighten: 2 N.m (18 lb in) |
| 2 | Rear Seat Riser Finish Cover |
| 3 | Rear Seat Riser Finish Cover |
| 4 | Rear Seat Riser Bolt (Qty: 2) Tighten: 9 N.m (80 lb in) |
| 5 | Rear Seat Riser Procedure: Disconnect the seat riser strut from the seat riser. |