Rear Seat Number 2 Load Floor Latch Cable Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat No. 2 Back Cushion Latch, Nuts & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the rear seat. Refer to Rear Number 2 Seat Replacement (Tahoe/Yukon/Escalade) or Rear Number 2 Seat Replacement (Suburban/Yukon XL) . Remove the rear seat cushion trim covers. Refer to Rear Seat Number 2 Cushion Panel Replacement (AS3) or Rear Seat Number 2 Cushion Panel Replacement (AW2) .
1	Rear Seat Latch Release Handle Refer to Rear Seat Latch Release Handle Replacement (Rear No. 2) .
2	Rear Seat No. 2 Back Cushion Latch Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
3	Rear Seat No. 2 Back Cushion Latch Bolt (Qty: 2) Tighten: 9 N.m (80 lb in)
4	Rear Seat No. 2 Back Cushion Latch Tip: Release the latch cables from the seat, note the locations for installation.