LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Stowage Box Lid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate.
  2. Remove the cargo box cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
  3. Remove the assist handle. Refer to Endgate Assist Handle Replacement (Avalanche) .
  4. Remove the top drain grate.
  5. Remove the cargo box bridge side inner panel. Refer to Cargo Box Bridge Side Inner Panel Replacement (Escalade EXT)  or Cargo Box Bridge Side Inner Panel Replacement (Avalanche) .
    6. Fig 1: View Of Cargo Stowage Box & Bolts
    GM1708946Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolt (2) from inside the cargo box stowage lid assembly.
  7. Remove the bolts (1) from the top of the stowage lid.
  8. Remove the cargo box stowage box water run channel.
  9. Remove the cargo box from the vehicle.
scientia non olet · About LEMON Manuals