LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Cargo Box Front Cover, Center Cover, and Rear Cover Replacement

Cargo Box Front Cover, Center Cover, and Rear Cover Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Cargo Stowage Box & Covers
GM1684069Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Rear Cargo Box Cover
Tip: 
  1. Open the endgate to access the latches.
  2. Remove the rear cargo panel by pulling the left and right cargo panel latches, located on the bottom of each cargo panel, forward to unlock the cargo panel latches.
  3. Lift the cargo panel up and then out from the side rails.
  4. The left latch must be locked in place before the right latch. The cargo cover panels may not lock in place correctly if this step is not completed exactly.
2 Center Cargo Box Cover
Tip: 
  1. Remove the center cargo panel by pulling the left and right cargo panel latches.
  2. Lift the cargo panel up and then out from the side rails.
  3. The left latch must be locked in place before the right latch. The cargo cover panels may not lock in place correctly if this step is not completed exactly.
3 Front Cargo Box Cover
Tip: 
  1. Remove the front cargo panel by pulling 2 left and 2 right cargo panel latches.
  2. Lift the cargo panel up and then out from the side rails.
  3. The left latches must be locked in place before the right latches. The cargo cover panels may not lock in place correctly if this step is not completed exactly.
4 Rear Cargo Stowage Box
scientia non olet · About LEMON Manuals