LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 172 (Lighting Systems) >> Repair Instructions >> Tail Lamp Bulb Replacement (GMC Yukon Two-mode Hybrid)

Tail Lamp Bulb Replacement (GMC Yukon Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Back Up Lamp, Turn Signal & Side Marker Bulbs
GM1965004Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the rear tail lamp. Refer to Tail Lamp Replacement (Cadillac)  or Tail Lamp Replacement (Avalanche)  or Tail Lamp Replacement (Tahoe/Yukon)  or Tail Lamp Replacement (GMC Yukon Two-mode Hybrid) .
1 Back Up Lamp Bulb
CAUTION: Refer to Halogen Bulb Caution .

Procedure

  1. Twist the bulb socket counter-clockwise and remove the bulb socket from the lamp housing.
  2. Pull the lamp bulb straight from the bulb socket.
2 Turn Signal Bulb
Tip:  The top of the rear lamp is (LED) Light Emitting Diode which is not serviceable.
3 Side Marker Bulb
Tip:  Twist the bulb socket and remove the side marker lamp bulb.
scientia non olet · About LEMON Manuals