Tail Lamp Replacement (GMC Yukon Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Tail Lamp Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Open the liftgate in order to access the tail lamp assembly screws.
1	Tail Lamp Assembly Screws (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb in)
2	Tail Lamp Electrical Harness Assembly Connector Tip: Disconnect the tail lamp bulb and side marker lamp bulb sockets from the lamp assembly.
3	Tail Lamp Assembly Tip: Upon installation, push inward on the outer edge of the tail lamp in order to seat the 2 locating pins to the outer body panel nuts.