Tail Lamp Replacement (Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screws (Qty: 2)
NOTE:
Refer to Fastener Notice
.
Tighten: 2 N.m (18 lb in) |
| 2 | Tail Lamp Assembly Locator Pins (Qty: 2) Tip: Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts. |
| 3 | Tail Lamp Retainers (Qty: 2) |
| 4 | Tail Lamp Wiring Harness Assembly Connector |
| 5 | Tail Lamp Assembly Tip: Upon installation of the tail lamp, push inward on the lamp in order to seat the 2 locator pins into the retainer nuts. |