Quarter Panel Upper Applique Replacement (Tahoe)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Quarter Panel Upper Applique & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Open the liftgate and/or rear compartment doors to access the applique panel. Remove the tail lamp assembly. Refer to Tail Lamp Replacement (Cadillac) or Tail Lamp Replacement (Avalanche) or Tail Lamp Replacement (Tahoe/Yukon) or Tail Lamp Replacement (GMC Yukon Two-mode Hybrid) .
1	Quarter Panel Upper Back Body Opening Frame Retainers (Qty: 2)
2	Quarter Panel Applique Attaching Fingers (Qty: 6)
3	Quarter Panel Applique Screws (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
4	Rear Quarter Panel Upper Applique Tighten: 2 N.m (18 lb in) Tip: Upon installation, ensure the back body panel retainers are secure. Align the outboard attaching fingers to the 3 slots in the quarter panel sheet metal. (Refer to sequence as shown.) Push the applique into position until fully seated. Ensure all the retainers are seated properly. Align the applique screw holes to the body retainers. Secure the screws.