LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Seat Heating System & Seat Cooling System) >> Repair Instructions >> Module Replacement - Ventilation Heat and Cool - Driver Seat Cushion (Escalade w/KB6)

Module Replacement - Ventilation Heat and Cool - Driver Seat Cushion (Escalade w/KB6)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Memory Seat Control Module & Components
GM1678396Courtesy of GENERAL MOTORS CORP.
Module Replacement - Ventilation Heat and Cool - Driver Seat Cushion (Escalade w/KB6)

Callout Component Name
Preliminary Procedure: 
Remove the front driver seat. Refer to Front Seat Replacement - Bucket .
1 Passenger Seat Adjuster Outer Finish Cover
Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat (Manual) or Seat Cushion Outer Trim Panel Replacement - Front Seat (Power) .
2 Passenger Seat Adjuster Inner Finish Cover
Refer to Seat Cushion Inner Trim Panel Replacement - Front .
3 Passenger Seat Riser Finish Cover
Tip:  Pull rearward to disengage the cover from the seat riser.
4 Passenger Seat Cushion Cover and Pad
Refer to Seat Cushion Trim Cover and Pad Replacement .
5 Heated Seat Module Nut (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)

6 Heated Seat Module
Tip:  Disconnect the electrical connector.