LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Rocker Panel Molding Replacement (Base) >> Removal Procedure

Removal Procedure

  1. Open the doors.
    2. Fig 1: Rocker Panel Molding
    GM826353Courtesy of GENERAL MOTORS CORP.
  2. Remove the front wheel flare. Refer to Front Wheel Opening Flare Replacement (Base)  or Front Wheel Opening Flare Replacement (WS2, BVX, Lower)  or Front Wheel Opening Flare Replacement (WS2, BVX, Upper) .
  3. Remove the rear wheel flare. Refer to Rear Wheel Opening Flare Replacement (SUT)  or Rear Wheel Opening Flare Replacement (SUV)  or Rear Wheel Opening Flare Replacement (WS2, BVX) .
  4. Remove the push-pins from the underside of the vehicle.
  5. Pull the molding away from the vehicle with sufficient pressure to disengage the retaining clips from the body.
  6. Remove the rocker panel molding from the vehicle.
scientia non olet · About LEMON Manuals