DTC : P0564-F0

DTC P0564-F0  : ACC Switch Signal Circuit Error

NOTE:  Before you troubleshoot, review the general troubleshooting information - Refer to:

1. DTC check

   - 1. Turn the vehicle to the ON mode.

   - 2. Clear the DTC with the HDS.

   Clear DTCs

   - 3. Turn the vehicle to the OFF (LOCK) mode.

   - 4. Turn the vehicle to the ON mode, then wait for at least 5 seconds.

   - 5. Check for DTCs with the HDS.

   Is DTC P0564-F0 indicated?

   YES 

   Check for loose terminals and poor connections in the multipurpose camera unit 20P connector. If they are OK, replace the Multipurpose Camera Unit .

   YES 

   If DTC P0564-11 or P0564-15 are also indicated,

   go to DTC P0564-11 - Refer to:

   DTC Troubleshooting: P0564-11 (2016 2017 2018)  or

   DTC Troubleshooting: P0564-11 (2019 2020 2021)

   or P0564-15 - Refer to:

   DTC Troubleshooting: P0564-15 (2016 2017 2018)  or

   DTC Troubleshooting: P0564-15 (2019 2020 2021) .

   NO 

   Intermittent failure, the system is OK at this time. Go to intermittent failures troubleshooting - Refer to:

   How to Troubleshoot the Adaptive Cruise Control (ACC) (2016 2017 2018) or

   How to Troubleshoot the Adaptive Cruise Control (ACC) (2019 2020 2021) .

   If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.