VSA System Symptom Troubleshooting Index

WARNING: This page is about a different variant/trim than selected.

When the vehicle has one of these symptoms, check for VSA diagnostic trouble codes (DTCs) with the HDS. If there are no DTCs, do the diagnostic procedure for the symptom, in the sequence listed, until you find the cause.

Symptom	Diagnostic procedure	Also check for
HDS does not communicate with the VSA modulator-control unit or the vehicle	Go to the DTC troubleshooting index .	Power and ground at the VSA modulator-control unit.
ABS indicator, brake system indicator (red), VSA indicator, or VSA OFF indicator does not come on at start-up (bulb check)	Do the gauge control module self-diagnostic function .
VSA OFF indicator does not go off	Do the VSA sensor neutral position memorization . Do the gauge control module self-diagnostic function . Replace the VSA modulator-control unit .
ABS indicator, brake system indicator (red), VSA indicator, and brake system indicator (amber) do not go off	NOTE: If any of the CAN communication failure DTC is indicated in other system, troubleshoot the DTC first. Check for open wire or short wire in the F-CAN circuit; - Between the gauge control module and the CAN gateway (F-CAN D_H, F-CAN D_L). - Between the VSA modulator-control unit and the CAN gateway (F-CAN B_H, F-CAN B_L, F-CAN C_H, F-CAN C_L). Check the VSA modulator-control unit power circuit. - +B_ABS/VSA_FSR, IG1_VSA/ABS Check the VSA modulator-control unit ground circuit (GND). Do the gauge control module self-diagnostic function .	Refer to the followings about the indicator operating condition; How to Troubleshoot the VSA System Refer to the followings about the circuit troubleshooting; Gauge control module connector for inputs and outputs VSA modulator-control unit connector for inputs and outputs VSA system circuit diagram Fuse to components index Ground to components index
VSA cannot be turned OFF	Symptom troubleshooting . Replace the VSA modulator-control unit .