EPS indicator does not go off

WARNING: This page is about a different variant/trim than selected.

Diagnostic Procedure

NOTE: If any of the CAN communication failure DTC is indicated in other system, troubleshoot the DTC first.

Check for open wire or short wire in the F-CAN circuit;
- Between the gauge control module and the CAN gateway (F-CAN D_H, F-CAN D_L).
- Between the EPS control unit and the CAN gateway (F-CAN C_H, F-CAN C_L).
Check the EPS control unit power circuit.
- +B_EPS, IG1_VSA/ABS
Check the EPS control unit ground circuit (GND).
Do the gauge control module self-diagnostic function .

Also check for

Refer to the followings about the indicator operating condition;

Refer to the followings about the circuit troubleshooting;