Blind Spot Information (BSI) System Symptom Troubleshooting Index (BSI)

WARNING: This page is about a different variant/trim than selected.

Symptom	Diagnostic procedure	Also check for
The BSI alert indicator comes on when no other vehicle is in the detectable area (Wrong indication)	Symptom troubleshooting .
The BSI does not come on when other vehicles are in the detectable area (No indication)	Symptom troubleshooting .
The BSI indicator does not come on	Symptom troubleshooting .
The BSI indicator does not go off	NOTE: If any of the CAN communication failure DTCs are indicated in other systems, troubleshoot the DTC first. Check for open wire or shorted wire in the B-CAN circuit; - Between the gauge control module and BSI radar unit (B-CAN_H, B-CAN _L) Check the left and/or right side BSI radar unit power circuit (IG1_OPTION) Check the left and/or right side BSI radar unit ground circuit (GND) Do the gauge control module self-diagnostic function .	Refer to the following about the indicator operating condition; How to Troubleshoot Refer to the following about the circuit troubleshooting; Gauge control module connector for inputs and outputs BSI radar unit connector for inputs and outputs BSI system circuit diagram Fuse to components index Ground to components index
The buzzer does not sound	Symptom troubleshooting .
The HDS does not communicate with the BSI system	Symptom troubleshooting .	Incorrect HDS software.