The BSI indicator does not go off (BSI)
WARNING: This page is about a different variant/trim than selected.
Diagnostic procedure
NOTE: If any of the CAN communication failure DTCs are indicated in other systems, troubleshoot the DTC first.
- Check for open wire or shorted wire in the B-CAN circuit;
-
- -
Between the gauge control module and BSI radar unit (B-CAN_H, B-CAN _L)
- -
- Check the left and/or right side BSI radar unit power circuit (IG1_OPTION)
- Check the left and/or right side BSI radar unit ground circuit (GND)
- Do the gauge control module self-diagnostic function .
Also check for
Refer to the following about the indicator operating condition;
Refer to the following about the circuit troubleshooting;