Fan, Fan Motor, and Shroud Removal and Installation: Removal

Remove the air intake scoop (see step 1 on INTAKE AIR RESONATOR REMOVAL/INSTALLATION ).
Remove the front bulkhead cover (see FRONT BULKHEAD COVER REPLACEMENT ).
Disconnect the A/C condenser fan motor connector (A), and coolant reservoir hose (B), then remove the coolant reservoir hose from the clamps (C).

Fig 1: Identifying A/C Condenser Fan Motor Connector, Coolant Reservoir Hose And Clamps
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the radiator brackets (A) and the condenser brackets (B).

Fig 2: Identifying Radiator Brackets, Condenser Brackets And Front Grille Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the front grille bolts (C).
Remove the A/C condenser fan shroud assembly (A).

Fig 3: View Of A/C Condenser Fan Shroud Assembly Off Vehicle
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the radiator fan motor connector (A) and remove the harness clamps (B).

Fig 4: Identifying Radiator Fan Motor Connector And Harness Clamps
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Raise the vehicle on the lift.
Remove the splash shield (see FRONT SPLASH SHIELD REPLACEMENT ).
Remove the ATF cooler hoses bracket bolt (A) and loosen the bolt (B).

Fig 5: Identifying ATF Cooler Hoses Bracket Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Lower the vehicle on the lift.
With security system: Disconnect the hood latch switch connector (A).

Fig 6: Identifying Hood Latch Switch Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the hood latch (B) with the wire.
Remove the radiator fan shroud assembly (A).
NOTE: Pull-up the radiator, then move the radiator fan shroud assembly toward the right side of the vehicle to allow for enough space to lift it up and away from the A/C condenser fan shroud assembly.

Fig 7: View Of Radiator Fan Shroud Assembly Off Vehicle
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disassemble the fan shrouds.

Fig 8: Disassemble View Of Fan Shrouds
Courtesy of AMERICAN HONDA MOTOR CO., INC.