LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Driveline/Axle >> Dynamic Damper Replacement

Dynamic Damper Replacement

  1. Remove the inboard joint (see INBOARD JOINT SIDE  ).
  2. Remove the dynamic damper band (see step  1 ).
  3. Remove the dynamic damper (A).

    Dynamic damper type 1 

    Fig 1: Identifying Dynamic Damper (Dynamic Damper Type 1)
    G06951309Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Dynamic damper type 2 

    Fig 2: Identifying Dynamic Damper (Dynamic Damper Type 2)
    G06951310Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install a new dynamic damper.
    NOTE: Be careful not to swap the dynamic dampers. Check the type of dynamic damper by its shape.

    Dynamic Damper Type 

    DYNAMIC DAMPERS REFERENCE CHART

    Model Driveshaft Type
    M/T Left 1
    Right 1
    CVT Left --
    Right 2
  5. Adjust the specified distance (A) between the outboard joint side and the dynamic damper edge.
    NOTE: Check the type of dynamic damper by its shape.

    Dynamic damper type 1 

    Fig 3: Identifying Distance Between Outboard Joint Side And Dynamic Damper Edge (Dynamic Damper Type 1)
    G06951311Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Dynamic damper type 2 

    Fig 4: Identifying Distance Between Outboard Joint Side And Dynamic Damper Edge (Dynamic Damper Type 2)
    G06951312Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Dynamic Damper Position 

    DYNAMIC DAMPER POSITION

    Model Driveshaft Dynamic damper type Specified distance (A)
    M/T Left 1 250.5-255.5 mm (9.862-10.059 in)
    Right 1 249.2-254.2 mm (9.811-10.008 in)
    CVT Left -- --
    Right 2 477.5-482.5 mm (18.799-18.996 in)
  6. Install a new dynamic damper band (see step  10 ).
  7. Install the inboard joint (see INBOARD JOINT SIDE  ).
scientia non olet · About LEMON Manuals