C-Pillar Outer Trim Replacement

NOTE:

Remove these items:
- Bed rail trim (see BED RAIL TRIM REPLACEMENT ).
- Rear roof trim (see REAR ROOF TRIM REPLACEMENT ).
- Front bed panel (see FRONT BED PANEL REMOVAL/INSTALLATION ).
- Cargo area front light (see HIGH MOUNT BRAKE LIGHT REPLACEMENT ).
Pull up on the rear end of the C-pillar outer trim (A), and slide the trim rearward to release it from the clips, then remove the trim. Take care not to scratch the trim or the body.

Fig 1: Identifying C-Pillar Outer Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the clips (A) from the body and discard them.

Fig 2: Identifying C-Pillar Outer Trim And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Replace all of the clips with new ones.
Install the new clips (A) on the trim (B).

Fig 3: Identifying Trim And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Hold the trim (A) up into position, and fit all the clips into the holes in the body, then push on the trim until the clips snap into place.

Fig 4: Identifying Trim With Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall all removed parts.