Bed Rail Trim Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the body.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Release the hooks (A) with the appropriate trim tool, then remove the trim cap (B), and remove the screw.

Fig 1: Identifying Trim Cap And Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Slide the bed rail trim (A) backward, and pull it up to release the hooks (B, C), then remove the trim.

Fig 2: Sliding Bed Rail Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the bed rail trim in the reverse order of removal, and note these items:
- Make sure all of the hooks (A) on the edge of the trim are hooked under the bed liner lip (B).
- Make sure all of the middle trim hooks (C) are engaged in the slots (D) on the bed rail.
- Before reinstalling the screw, push up on the edge of the trim with moderate finger pressure. If any part of the trim lifts up, remove the trim and reinstall it.
Fig 3: Locating Middle Trim Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.