Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the sealing surfaces.
- Install the water outlet (3) to the engine block with a NEW seal (2) and tighten the fasteners (1) to 12 N.m (106 lb in).
- Install the heater outlet hose (3) and the radiator inlet hose (2) to the water outlet.
- Connect the ECT sensor connector (1).
- Install the thermostat bypass hose (2) to the water outlet (3)..
- Install the thermostat bypass pipe using a NEW gasket.
- Install the thermostat bypass pipe fasteners and tighten them to 10 N.m (89 lb in).
- If equipped with RPO code LTG, install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (LTG) .
- If equipped with RPO code LCV, install the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LTG) .
- Install the engine harness ground cables (2) to the engine block and tighten the fastener (1) to 25 N.m (18 lb ft).
- Install Vacuum Pump Vacuum Pump Replacement
- Install the fuel pump cover. Refer to Fuel Pump Cover Replacement .
- Install the plenum front panel. Refer to Plenum Front Panel Replacement .
- Fill the cooling system. Refer to Cooling System Draining and Filling (Static) Cooling System Draining and Filling (GE 47716) .
- Start the engine and check for coolant leaks.
CAUTION:
Refer to Fastener Caution .