Installation Procedure
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
- Install a NEW O-ring seal.(2)
- Install Radiator Outlet Pipe (3)
- Radiator Outlet Pipe Bracket Bolt (1) Tighten 22 N.m (16 lb ft)
- Connect the engine electrical wiring harness retainers (1).
- Connect Heater Outlet Hose (2) @Heater Core - Heater Outlet Hose Replacement (LF4)
- Connect Heater Inlet Hose (2) @Heater Core - Heater Inlet Hose Replacement (LF4)
- Install Radiator Outlet Pipe Bracket Bolt (1) and tighten 22 N.m (16 lb ft)
- Connect Radiator Outlet Hose (2) - Radiator Outlet Hose Replacement (LF4)
- Install Engine Oil Cooler Adapter (2) - Engine Oil Cooler Adapter Replacement (LF4)
- Starter (4) - Starter Replacement (LF4 - Manual Transmission)Starter Replacement (LF4 - Automatic Transmission)
- Install Catalytic Converter (3) - Catalytic Converter Replacement - Right Side (LF4)
- Connect Transmission Fluid Cooler Inlet and Outlet Pipe (2) @Transmission - Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LF4 With MG9)Transmission Fluid Cooler Inlet and Outlet Pipe Replacement (LF4 With M5U)
- Install Engine Mount Bracket - Right Side (4) - Engine Mount Bracket Replacement - Right Side (LF4)
- Drivetrain and Front Suspension Frame Removal and Installation (LF4)
- Fill the cooling system. Cooling System Draining and Filling (Static) Cooling System Draining and Filling (GE 47716)
CAUTION:
Refer to Fastener Caution .