Input Speed Sensor Seal Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Input Speed Sensor Seal

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Drain the transmission, refill when repair is completed. Refer to Transmission Fluid Drain and Fill . Remove the left wheel house. Refer to Front Wheelhouse Liner Replacement (Equinox)Front Wheelhouse Liner Replacement (Terrain) .
1	Input Speed Sensor Bolt M6 x 25 CAUTION: Refer to Fastener Caution . TIP: Apply threadlocker to the input speed sensor bolt. Refer to Adhesives, Fluids, Lubricants, and Sealers for the recommended threadlock material. Tighten 9 N.m (80 lb in)
2	Input Speed Sensor (ISS) TIP: Pull the ISS out of the case cover just far enough to gain access to the ISS seal.
3	Input Speed Sensor Seal Remove the ISS seal by pulling it over the end of the ISS base. Install the new ISS seal by gently stretching it over the ISS base. Overstretching the seal will cause it to not seal properly. The seal is coated with a dry lubricant. If the coating is missing, lubricate the seal with automatic transmission fluid prior to installation.